Upgrade Your Bathroom: How To Install Your Kohler Elongated Toilet In No Time
What To Know
- Installing a Kohler elongated toilet is a straightforward task that can be completed in a few hours.
- Apply penetrating oil to the bolts and let it sit for a few minutes.
- Then, use an impact wrench or a socket wrench with a cheater bar to break the bolts loose.
Are you looking to upgrade your bathroom with a comfortable and stylish Kohler elongated toilet? Installing one yourself can be a rewarding and cost-effective project. This comprehensive guide will walk you through the entire process, from gathering the necessary tools to completing the installation.
Materials and Tools
Before you begin, gather the following materials and tools:
- Kohler elongated toilet
- Toilet wax ring
- Toilet flange bolts
- Toilet seat and lid
- Adjustable wrench
- Plumber’s putty
- Level
- Measuring tape
- Hacksaw
Safety Precautions
Always follow these safety precautions before starting any installation work:
- Shut off the water supply to the toilet.
- Wear safety glasses and gloves.
- Avoid inhaling dust or fumes.
Step-by-Step Installation Guide
1. Remove the Old Toilet
- Disconnect the water supply line.
- Remove the nuts holding the toilet to the floor.
- Carefully lift the toilet off the flange and set it aside.
- Clean the floor around the flange.
2. Install the Toilet Flange Bolts
- Insert the toilet flange bolts into the holes in the flange.
- Adjust the bolts so that they are level.
3. Apply the Toilet Wax Ring
- Place the wax ring on the toilet flange.
- Make sure the wax is centered and pressed down firmly.
4. Set the Toilet on the Flange
- Carefully lift the toilet and place it on the flange.
- Align the bolts with the holes in the toilet base.
- Lower the toilet until it rests on the wax ring.
5. Tighten the Toilet Bolts
- Use the adjustable wrench to tighten the toilet bolts.
- Do not overtighten the bolts, as this can crack the toilet.
6. Install the Toilet Seat
- Attach the toilet seat to the toilet bowl.
- Tighten the nuts until the seat is secure but not too tight.
7. Connect the Water Supply
- Connect the water supply line to the fill valve on the toilet.
- Turn on the water supply and check for leaks.
8. Apply Plumber’s Putty
- Apply a bead of plumber’s putty around the base of the toilet where it meets the floor.
- Smooth out the putty to create a watertight seal.
Troubleshooting Tips
- Toilet wobbles: Check if the flange bolts are loose or the wax ring is not properly seated.
- Water leaks: Inspect the water supply line connections, fill valve, and wax ring for leaks.
- Toilet clogs frequently: Check the water level in the tank, clean the siphon jet, and inspect the trapway for obstructions.
Wrapping Up
Installing a Kohler elongated toilet is a straightforward task that can be completed in a few hours. By following these instructions carefully, you can upgrade your bathroom with a comfortable and stylish toilet that will last for years to come.
Frequently Asked Questions (FAQs)
Q: What is the best way to remove a stuck toilet bolt?
A: Apply penetrating oil to the bolts and let it sit for a few minutes. Then, use an impact wrench or a socket wrench with a cheater bar to break the bolts loose.
Q: How do I know if the wax ring is properly seated?
A: The wax ring should be compressed about 1/4 inch when the toilet is installed. You can check this by looking at the wax ring after the toilet is set in place.
Q: What should I do if I accidentally crack the toilet bowl?
A: If the crack is small, you can repair it with epoxy. For larger cracks, you will need to replace the toilet.
