Say Goodbye to Drawer Struggles! Discover the Secret to Perfect Drawer Placement

Putting drawers back in a dresser can be a daunting task, but it doesn’t have to be. With the right tools and a bit of patience, you can get the job done quickly and easily. In this comprehensive guide, we’ll provide you with step-by-step instructions on how to put drawers back in dresser, ensuring that they slide smoothly and remain securely in place.

Tools and Materials

Before you begin, gather the following tools and materials:

• Screwdriver (Phillips or flathead, depending on the dresser)
• Hammer
• Nails (optional)
• Drawer slides
• Drawers

Step 1: Remove the Old Drawers

1. Open the drawer fully.
2. Locate the screws or nails that secure the drawer slides to the dresser sides.
3. Remove the screws or nails using the appropriate tool.
4. Carefully pull the drawer out of the dresser.

Step 2: Clean the Drawer Slides

Once the drawers are removed, it’s a good idea to clean the drawer slides. This will help ensure smooth operation and prevent any debris from interfering with the drawer’s movement.

1. Use a damp cloth to wipe down the drawer slides.
2. If there is any stubborn dirt or grime, you can use a mild cleaner and a soft brush to remove it.
3. Allow the drawer slides to dry completely before proceeding.

Step 3: Install the Drawer Slides

1. Insert the drawer slides into the appropriate slots on the dresser sides.
2. Secure the drawer slides using the screws or nails that you removed earlier.
3. Make sure that the drawer slides are level and parallel to each other.

Step 4: Adjust the Drawer Slides

Once the drawer slides are installed, you may need to adjust them to ensure that the drawer opens and closes smoothly.

1. Open and close the drawer several times to check its movement.
2. If the drawer is too tight, loosen the screws on the drawer slides slightly and adjust the slide’s position.
3. If the drawer is too loose, tighten the screws on the drawer slides and adjust the slide’s position.

Step 5: Insert the Drawers

1. Lift the drawer and align it with the drawer slides.
2. Carefully slide the drawer into the dresser until it is fully seated.
3. Make sure that the drawer is level and does not tilt to one side.

Step 6: Secure the Drawers

Once the drawers are inserted, you may need to secure them further to prevent them from falling out.

1. Some dressers have a built-in locking mechanism that secures the drawers. If your dresser has this feature, engage the lock to secure the drawers.
2. If your dresser does not have a built-in locking mechanism, you can install drawer stops or drawer slides with a locking feature.

Step 7: Finishing Touches

Once the drawers are secured, you can add the finishing touches.

1. Wipe down the exterior of the dresser and drawers with a clean cloth.
2. If desired, you can add drawer knobs or pulls to enhance the look of the dresser.

Wrapping Up

By following these step-by-step instructions, you can easily put drawers back in dresser and restore its functionality. With a little care and attention, your dresser will look and work like new again.

Frequently Asked Questions

Q: What should I do if my drawer slides are broken?
A: If your drawer slides are broken or damaged, you will need to replace them. You can purchase replacement drawer slides at most hardware stores.

Q: How can I prevent my drawers from sticking?
A: To prevent your drawers from sticking, make sure that the drawer slides are properly aligned and lubricated. You can apply a small amount of furniture wax or silicone spray to the drawer slides to reduce friction.

Q: What is the best way to clean drawer slides?
A: To clean drawer slides, use a damp cloth to wipe away any dirt or debris. If there is any stubborn grime, you can use a mild cleaner and a soft brush to remove it. Allow the drawer slides to dry completely before using them again.